Preparation
SERVO-DRIVE for AVENTOS only has a few
components that can be attached easily.
The requirement is that the front is in balance.
Cabling
First insert the distribution cable
into the drive unit and secure it.
Attaching
Then the drive unit is attached to
the lift mechanism.
Locking
To lock the drive unit, the top
slide must be pulled back and/or
the bottom slide pulled forward.
Installing
The distribution cable connected to
the drive unit is run through a drilling at the back.
Connecting
Thanks to piercing technology, the power
supply can be set up with ease and flexibility.
Covering
Once everything is connected, the cover
cap is placed on the lift mechanism and drive unit.
Installing the switch and distance bumper
The switch used to close the front is attached
to an easily accessible area at the bottom of
the cabinet side. It is simply pressed in. Only an 3/4 drilling
is required for this. Distance bumper installation
also requires a drilling. It is also only pressed
in and ensures the required trigger path of 2 mm.
